Switch Off - Warmtech CACG10KW Traduction Des Instructions D'origine

Figure.3
c. As the flame lights up, keep the valve button pushed for 10 seconds approx.
Should the heater stop when the valve button has been released, wait one minute
and repeat the starting operation keeping the valve button pushed for a longer
time.
d. Contact your supplier should any problem continue.
CAUTION
If ignition is difficult or irregular before repeating the ignition operations make
sure that the fan is not locked and the air inlet and outlet are unobstructed.

3.2 SWITCH OFF

To stop the heater, shut off the gas cylinder tap. Let the fan run until the flame shuts
down and then turn the fan switch to position O.
3.3 AIR CONDITIONING
a. The heater can also be used as a ventilator.
b. In this case remove the gas supply hose and connect the plug of heater to a
suitable electrical supply.
c. Set the fan switch to position I.
Fig.4