Product Specifications; Features; Assembly; Assembling The Handle - Ryobi DEVOUR P3260 Manuel D'utilisation

PRODUCT SPECIFICATIONS

Canister Capacity ..............................................4.5 gallons
Brush Rotation ............................ approximately 155 RPM
UNPACKING
This product requires assembly.
 Carefully remove the tool and any accessories from the
box. All items listed in the Includes section must be
included at the time of purchase.
WARNING:
Items in this Assembly section are not assembled to
the product by the manufacturer and require customer
installation. Use of a product that may have been
improperly assembled could result in serious personal
injury.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended for use
with this product. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possible serious personal injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from the
tool when assembling parts.

FEATURES

Cleaning Width .......................................................... 21 in.

ASSEMBLY

ASSEMBLING THE HANDLE

See Figure 1, page 11.
CAUTION:
Be careful to avoid pinching your fingers or hands when
installing the handle onto the frame.
 Insert the lower handles into the holes on each side of
the upper handle as shown.
 Push and hold the push-pin button on the lower handles.
 Slide the lower handles into the upper handle until the
buttons snap into one of the holes.
NOTE: Shorten or lengthen the handle assembly by
selecting different holes.
ATTACHING THE HANDLE ASSEMBLY
See Figures 2 - 4, page 11.
 Loosen and remove the handle lock knobs from the posts
on both sides of the sweeper.
 Slide the handle assembly onto the posts.
NOTE: The smooth side of the handle assembly should
face away from the post as shown in figure 4.
 Replace the adjustment knobs and tighten to secure the
handle assembly in place. Do not overtighten.
 Position handle assembly in a comfortable operating
position, between the front and rear detents.
NOTE: If it is difficult to move the handle assembly, loosen
the handle lock knobs. If the handle assembly is too loose,
tighten the adjustment knobs.
6 — English