Rommelsbacher KML 2501 Mode D'emploi page 16

ATTENTION: Our mini kitchener has an automatic oven priority regulation, which restricts the electrical
power to 3000 Watt and thus enables the appliance to be connected to any socket.
This means that the large heating zone can only be operated, when the switch of the oven is on „0"
position, i.e. no simultaneous operation of large heating zone and oven is possible!
Using the cooktop
• Do not use any cooking pots consisting of plastic, inferior china, enamel or aluminium foil.
• In case any objects made up of plastic, aluminium foil, sugar – or dishes containing sugar – inadvertently
happen to melt on the hot ceramic hob, shove them away from the hot cooking area immediately by using a
cleaning scraper.
• Avoid scratches on the glass plate produced by pointed or sharp objects. Protect the glass plate from breaking
caused by falling objects. Damage caused by non-observance of these guidelines is not covered by the warranty.
• The heating zones are regulated via an energy control, which enables varying the regulation infinitely from
keeping warm (approx. 7 % of the power) to maximum temperature (100 % power).
• Please use the following settings:
step1-5
step 4-9
step 8-12
• The residual heat indicator on the front part of the cooking surface point to still prevailing risks of burning but
also to residual heat which can be used for keeping dishes warm.
Using the oven
• With the lower rotary switch you can vary the oven temperature for the function „upper and lower heat"
infinitely from 50 °C to 250 °Cor choose the functions „only lower heat „, „only upper heat" or „grill", where the
oven is heating with maximum power. In the upper part of the oven there are 2 heating elements, whereby the
inner one provides for the grilling function, the outer one is working when setting the function "only upper heat"
or "upper and lower heat".
• To switch on the oven, turn the above rotary switch to the right as far as it will go and then back to the desired
operation time or turn it left and choose "M" = continuous operation.
• The oven is in operation now, the pilot lamps are going on, and the heating process is beginning.
• Operating with timer, the oven switches off automatically when the set time is over, and a bell rings shortly. The
operation time can always be changed by turning the switch to the right or left.
• Being adjusted for continuous operation "M", the appliance does not switch off automatically. For switching it
off the rotary switch has to be turned back to "0".
• While the oven is operated, its interior light is shining and enables you to observe your dishes.
• When the lower pilot lamp goes out, the set oven temperature is reached. The alternately lighting up and going
out of the lamp during the operation shows the thermostatic regulation of the oven temperature.
• The upper pilot lamp indicates that at least one of the functions is in operation. Please be aware of this pilot
lamp shining also when the heating plate of 180 mm ∅ is switched on in addition to the oven but is not heating
because of the oven priority regulation.
• The oven door is equipped with a seal, a certain air exchange, however, is required. As this can cause slightly
diverging temperatures in the front and back part of the oven, we recommend turning the dishes when half of
the preparing time is over.
16
to warm up and keep warm
to cook, stew and steam
to start cooking, bake and fry