Rommelsbacher KML 2501 Mode D'emploi page 15

Model KM 2501
Initial use
Heat the heating plates without a pot for approximately 5 minutes at maximum setting. This will give
optimal protection to the coating on the plates.
Afterwards heat the oven for approximately 10 minutes at maximum temperature on function „upper
and lower heat" and following that set it for the function „grill" for 10 minutes as well. In this way the protective
coating of the various heating elements is burned in. Please disregard the temporary formation of smoke.
ATTENTION: Our mini kitchener has an automatic oven priority regulation, which restricts the electrical
power to 2500 Watt and thus enables the appliance to be connected to any socket.
This means that the large heating zone can only be operated, when the switch of the oven is on „0"
position, i.e. no simultaneous operation of large heating zone and oven is possible!
Using the cooking plates
• The plates are regulated via 7-step switches. Please use the following settings:
step 1-2
step 3-4
step 5-6
Using the oven
• With the lower rotary switch you can vary the oven temperature for the function „upper and lower heat"
infinitely from 50 °C to 250 °C or choose the functions „only lower heat „, „only upper heat" or „grill", where the
oven is heating with maximum power. In the upper part of the oven there are 2 heating elements, whereby the
inner one provides for the grilling function, the outer one is working when setting the function "only upper heat"
or "upper and lower heat".
• While the oven is operated, its interior light is shining and enables you to observe your dishes.
• When the lower pilot lamp goes out, the set oven temperature is reached. The alternately lighting up and going
out of the lamp during the operation shows the thermostatic regulation of the oven temperature.
• The upper pilot lamp indicates that at least one of the functions is in operation. Please be aware of this pilot
lamp shining also when the heating plate of 180 mm ∅ is switched on in addition to the oven but is not heating
because of the oven priority regulation.
• The upper pilot lamp indicates that at least one of the heating plates is switched on. Please be aware of this
pilot lamp shining also when the heating plate of 180 mm ∅ is switched on in addition to the oven but is not
heating because of the oven priority regulation.
• The oven door is equipped with a seal, a certain air exchange, however, is required. As this can cause slightly
diverging temperatures in the front and back part of the oven, we recommend to turn the dishes when half of
the preparing time is over.
Model KML 3001
Initial use
Heat the oven for 10 minutes at maximum temperature, setting the regular switch at "M" and the selection
switch for maximum temperature on the function "upper and lower heat".
Following thatset the switch at function "grill" for 10 minutes as well.
In this way the protective coating of the various heating elements is burned in. Please disregard the temporary
formation of smoke.
to prepare smaller quantities, to warm up and keep warm
to prepare larger quantities, to fry, cook and steam
full power to start cooking and to deep-fry
15