Télécharger Imprimer la page

EWT FUTUR 110LCD Mode D'emploi page 4

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11
UK
..
Dear Customer,
Please read the following information carefully
before using the appliance for the first time for
your own safety and to ensure correct use.
Attention! The appliance may only be used for
normal domestic use and not for industrial
purposes.
Important safety advice
• The appliance must only be used as described
in the instructions for use! Use for any other
purpose is forbidden! Any damage resulting from
improper use and non-observance of the safety
information
will
invalidate
any
warranty!
• All liability is disclaimed for any frost damage
caused by a heating capacity that is insufficient for
the room size, bad heat insulation of the room,
incorrect use or force majeure (e.g. power failure).
• Only connect the appliance to A.C. mains as
specified on the rating plate!
• Never touch live parts! Danger to life!
• Never operate the appliance with wet hands!
Danger to life!
• The appliance must be placed in a way that the
control elements cannot be touched by persons
who are in bath, shower, or any other water-filled
receptacle.
• Do not use the appliance in rooms with bath,
shower or swimming pool or in the vicinity of wash
basins or water connections!
• Do not expose the appliance to rain or other
moisture! The appliance is nor for outdoor use.
The appliance must only be stored indoors!
• Never use the appliance if the appliance or cord
is damaged. Risk of injury!
• Check the power cord regularly for damage.
• If the power cord or if the appliance is damaged
to the extent that electrical parts are exposed,
disconnect it immediately from the mains and see
your authorised retailer!
• Improper repairs can expose the user to
considerable danger.
• The appliance may only be opened up and
repaired by authorised qualified personnel.
• Do not store or use any flammable materials or
sprays in the vicinity of the appliance when the
appliance is in use. Fire hazard!
• Do not use the appliance in flammable
atmospheres (e.g. in the vicinity of combustible
gases or spray cans)! Explosion and fire
hazard!!
• The appliance should not be used in areas
which are a fire risk, such as garages, stables, or
wooden sheds.
• Important! Do not insert any foreign objects into
the appliance openings! Risk of injury (electric
shock) and damage to the appliance!
• The appliance air inlet and outlet openings must
not be obstructed in any way!
• Place the appliance so that it cannot be touched
by accident. Risk of burns!
WARNING:
IN
ORDER
OVERHEATING,
DO
NOT
HEATER.
The heater carries the Warning symbol indicating
that it must not be covered.
• The appliance is not suitable for connection to
permanent wiring!
• The appliance is not intended for use by young
children or infirm persons without supervision!
• Young children should be supervised to ensure
that they do not play with the appliance!
• The socket-outlet must be accessible at all times
to enable the mains plug to be disconnected as
quickly as possible!
• Attention! To avoid any danger due to
unintentionally resetting the thermal cut-out, the
appliance must not be supplied via a timer.
• The appliance is not suitable for animal breeding
purposes!
• The instruction leaflet belongs to the appliance
and must be kept in a safe place. When changing
owners, the leaflet must be surrendered to the
new owner!
Packaging
• After unpacking the appliance, check the same
for transport damage and the contents for
completeness! In the event of damage or an
incomplete delivery, contact your authorised
retailer!
• Do not discard the original box! It can be used
for storage and dispatch to avoid transport
damage!
• Dispose of the packaging material in a proper
manner! Plastic bags should be kept away from
children!
liability
and
Location
• The appliance should be placed with a minimum
distance of 50cm from flammable objects, walls or
other structures! The appliance openings must not
be obstructed in any way!
• Do not place the appliance on instable surfaces
(e.g. a bed), where it can tip over!
• The appliance must not be located below a
socket outlet!
• The appliance must not be operated directly on
high pile carpets.
Power cord
• Only use an approved extension cord that is
suitable for the appliance rating!
• Position the power cord so that it does not pose
a tripping hazard and possibly cause the
appliance to be knocked over.
• The power cord must not come into contact with
hot appliance parts!
• Never pull the plug out of the socket at the cord!
• Never move the appliance by pulling at the cord
or use the cord for carrying purposes!
• Do not coil the cord around the appliance! Do
not use the appliance with the cord coiled!
This applies particularly if a cable drum is used.
• Do not crush the cord or drag it over sharp
edges. Do not place it over heated hotplates or
naked flames!
Start up
• After switching on the appliance for the first time
and after an extended period of non-use, a smell
may be noticed for a short time.
• To use, insert the plug in the socket.
Switch (S) (see fig. 2)
With the selector, the fan can be switched on or
the power setting selected.
Thermostat (T) (see fig. 2)
In order to maintain a certain room temperature,
set the controller to "max.". Operate the appliance
at full power until the required room temperature
TO
AVOID
is reached. Set back the thermostatic controller
COVER
THE
until the appliance switches off with an audible
"click". This temperature will be kept almost
constant by the thermostatic control switching on
and off automatically.
Please note that the appliance can only be
switched on when the thermostat setting is higher
then the room temperature.
Attention! The unit is ready for use even when at
the lowest setting .
In order to switch off the appliance, pull out the
power supply plug.
Operation - see Fig. 3
The heat output is electronically controlled,
according to the room temperature.
To activate the appliance press the standby
button - see '1' in Fig. 3. Press button '2' to select
Fan only/Low heat/High heat. By pressing this
button once Fan only is selected, pressing twice
provides Low heat and by pressing three times
High heat is selected.
On the display screen
temperature readings appear at the top of the
screen. The room ambient temperature appears
on the right and the desired temperature appears
on the left hand side.
Use buttons '3' and '4' to set the desired room
temperature when Low or High heat is selected.
The temperature can be set from 5°C and 35°C
and this will be shown on the display. When the
temperature
automatically
temperature drops the heater will come on again
automatically. Note the electronic climate control
device
temperature regulation e.g. if the heater is set to
HIGH heat and the temperature is set to 28°C, at
27°C the heater will switch to LOW heat. Then at
28°C the heater will switch OFF completely.
An audible beep can be heard when any button is
pressed.
A double beep can be heard when 5°C and 35°C
is selected; the upper and lower limits.
By keeping buttons '3' and '4' pressed down the
user can scroll quickly to the desired temperature.
Note: The heater retains it's last setting once the
appliance has been switched off or disconnected
from the power supply.
Transport (see fig. 4)
The appliance is provided with a handle for easy
carrying
Frost protection (see fig.2)
• Set the controller (T) to
to the required the heating output.
• When the temperature falls below +5 °C...+8 °C,
the appliance switches on automatically.
Overheat cut-out
The built-in overheat cut-out switches off the
appliance automatically in the event of a fault!
Switch off the appliance (set switch to "0" and
thermostat to ) or disconnect the mains plug
from the socket. After a short cooling down phase,
the appliance is ready for use again! If the fault
should occur again, see your local dealer!
Cleaning
• Switch off the appliance first and disconnect the
plug from the socket!
• Clean the housing with a moist cloth, vacuum
cleaner or brush.
• Do not use any abrasive or caustic cleaning
agents!
• Do not use any flammable cleaning agents e.g.
petrol or spirit for cleaning the appliance.
• Never immerse the appliance in water! Danger
to life!
• Air inlet- and outlet area should be cleaned with
a vacuum cleaner regularly
• If the appliance is not used for extended
periods, it must be protected against excessive
dust and dirt.
Recycling
Check with your Local Authority or retailer for
recycling advice in your country.
After sales service
All repairs must be referred to authorised
personnel!
See your local dealer.
Any tampering with the appliance will invalidate
the warranty.
Repairs carried out improperly and by unqualified
persons may have serious consequences for the
user!
In the interests of further development, the
appliance may be subject to constructional or
design changes without prior notice.
(see
Fig. 3)
two
is
reached
the
heater
switch
off.
If
the
conserves
energy
and
assists
and the controller (S)
For electrical products sold
within
the
European
Community.
At the end of the electrical
products useful life it should
not be
disposed of
household
waste.
recycle where facilities exist.
will
ambient
with
with
Please

Publicité

loading

Ce manuel est également adapté pour:

Futur 100tls