Assembly - Batavus T3 Mode D'emploi

ASSEMBLY

As for the assembly of the device, we recommend two
grown-up persons. Do not take the treadmill out of the
box: use the packing material to cover the floor on the
assembly site.
Before assembling the device, insure all parts are
present:
Frame
1.
Power cord
2.
Assembly kit (contents are marked with an * in the
3.
spare part list): keep the assembly tools, as you may
need them e.g. for adjusting the equipment
In case of problems contact your Batavus dealer. The
directions left, right, front and back are defined as
seen from the exercising position. To avoid injury,
you must fold up the deck prior to lifting the treadmill
out of the box.
Locate the hardware bag and parts that are listed in
the chart below.
Part# Description
A Main frame and console 1
B Screw
C Washer
D Washer
E Screw
F Allen key
G Screwdriver
H Safety Key
I Side cap
Lift up the upright, then place the screws (B) and
washers (C, D) inside holes at the bottom of the
upright. Tighten them well.
BatavusT3_3.indd 11
Put the console to the correct position. Tighten the
screws (B) and washers (D) inside holes at the top of
the upright.
Attach the side caps (I) with screws (E) at the bottom
of the upright, and tighten them well.
A
Q´TY
6
2
4
6
1
1
1
POWER CORD AND GROUNDING
2
INSTRUCTIONS
Plug the socket end of the power cord into the
treadmill at the left front corner. Before connecting
the device to a power source, make sure that local
voltage matches that indicated on the type plate. The
treadmill operates at 110 V or 230 V.
This treadmill must be grounded. If it should
malfunction or breakdown, grounding provides a
path of least resistance for electrical current to reduce
the risk of electrical shock. This product is equipped
with a cord having an equipment-grounded conductor
and a grounding plug. The plug must be plugged
into an appropriate outlet that is properly installed
and grounded in accordance with all local codes
and ordinances. Do not use extension cables when
connecting the equipment to the power source.
DANGER!
grounding conductor can result in a risk of electric
shock. Check with a qualified electrician or
O W N E R ' S M A N U A L • T 3
Improper connection of the equipment-
G B
11
31.7.2008 14:48:11