Water Drainage; Starting The Machine - Kruger SECOMAT 160 Mode D'emploi

Masquer les pouces Voir aussi pour SECOMAT 160:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

tive. The Model AH is equipped with a
heating element, which is automatically
switched on at temperatures below 15°C.
This heater only serves as support for the
functioning of the appliance and is not to
be used as heating for the room.

Water drainage

Wherever possible, the water should
drain automatically.
• Attach connector piece (optional extra)
to the screw thread (7) at the bottom
of the machine
• Put the hose (optional extra) over the
connector piece
• Put the other end of the hose into the
waste pipe (preferably siphoned)
If the water is collected in a tank, it must
be regularly checked and emptied. De-
pending on the temperature and mois-
ture content of the air, the tank may need
to be emptied 1 – 2 times a day.
If the tank is not emptied, this can lead
to water damage.
Hanging up the washing
• Leave a minimum gap of 30 cm be-
tween the clothes and the machine
• Hang heavy cotton items (e.g. towel-
ing, jeans, pullovers etc.) in the air flow
near the machine
• Hang large items over two lines or at-
tach to two lines
• Ensure that the air circulation in the
room is adequate
• Do not obstruct the intake and outlet
openings
The most cost-effective way of drying
clothes is not to switch on the clothes
drier until:
a) you have hung up all the washing.
b) the drying room is full.
If other items are added during the drying
process, the drying time is increased.

Starting the machine

• Close doors and windows
• Check machine is plugged into the
mains
• Set hygrostat controller (1) to 45% rel-
ative humidity (washing should be dry
at this setting). If the washing is not dry
enough or is too dry, you can change
the setting as follows:
Washing is not dry enough
Set hygrostat to 35 – 40%
Washing is too dry
Set hygrostat to 50 – 55%
• SECOMAT 160 AH
STOP
DRY
20
30
• To switch on: Press the 'I' button
The clothes drier works automatically,
i.e. as long as the humidity in the room
remains above the preset value, it con-
tinues to operate. As soon as the set level
of humidity is reached, the dehumidify-
ing function of the clothes drier stops.
If the humidity level in the room rises
again, it automatically restarts.
• To switch off: Press the 'I' button
• SECOMAT 160 E
(with end stop)
• To switch on: Press the 'I' button
The clothes drier works automatically,
i.e. as long as the humidity in the room
remains above the preset value, it con-
tinues to operate. As soon as the set level
of humidity is reached, the clothes drier
switches off completely, i.e. it does not
come on again if the humidity level in
the room rises again. The drying process
can be interrupted at any time by press-
ing the 'O' button.
Cleaning
The refrigeration unit is hermetically
sealed and the fan bearings are provided
with lifetime lubrication. These parts are
therefore maintenance-free.
• Wipe the housing with a damp cloth.
• Take hold of the filter grip (4) at the top
of the front grill (5). Pull the filter up-
ward and remove.
• Remove dust from air filter using a
brush and replace.
If it becomes particularly dirty, the inside
70
of the machine will need to be cleaned.
60
This must be performed by a refrigera-
50
40
tion specialist.
TROUBLESHOOTING
Please check the following points be-
fore taking the machine to a specialist
STOP
70
DRY
dealer.
60
20
50
40
30
A. Machine does not start
• Is the mains plug correctly inserted?
• Is the fuse in your fusebox OK?
• Is the mains cable or extension cable
(if used) OK?
• Is the hygrostat controller set correctly
(to approx. 45% relative humidity)?
B. Machine is running constantly
• Is the hygrostat controller set to ap-
prox. 45% relative humidity?
• Are the doors and windows closed?
C. The machine is not dehumidifying
the room properly
• Is the air circulation in the room ade-
quate? Does the room have sufficient
air circulation? The air outflow louvers
can be repositioned to change the air-
flow direction, they must not be closed
however.
• Are the intake and outlet openings free
of obstructions?
• Is the room temperature too high or
too low (see section on Installation)?
• Is the filter clean?
If you have checked the above points and
still not managed to rectify the fault, the
machine must be taken to a refrigeration
specialist for inspection.
DISPOSAL
Because the clothes drier contains a
refrigerant, it requires special disposal.
Please contact your specialist dealer or
local waste disposal authority.

Publicité

Table des Matières
loading

Table des Matières