LEXIBOOK Move Cam Touch Mode D'emploi page 19

r position)
screw
screw
r position)
ded:
anual
ets, wire
ded.
move the
follows:
computer
atteries
for the
screen,
DJA200_01IM1264_26Jun_V02.indb 19
The lithium battery is intended for use only with this product. Do not
disassemble the battery. Do not dispose of the battery in fire or water.
To avoid risk of fire, burns, or damage to your battery, do not allow
a metal object to touch the battery contacts. Handle a damaged or
leaking battery with extreme care. If it contacts the eye, flush the
eye with water for 15 minutes and seek medical attention. Do not
charge the lithium battery pack if the ambient temperature exceeds
45°C (113°F). When discarding a battery pack, contact your local
waste disposal provider regarding local restrictions on the disposal or
recycling of batteries. Only use the supplied USB cable for charging.
WARNING: Malfunction or loss of memory may be caused by strong
frequency interference or electrostatic discharge. Should any abnormal
function occur, reset the unit and turn it on again.
TURNING THE CAMCORDER ON AND OFF
Press and hold the Power button (3) to turn the camcorder on.
When you turn the camcorder on, the green Busy LED indicator (4)
illuminates. The LCD screen lights up to confirm the camcorder is
ready for use.
Press the Power button (3) once more to turn the camcorder off. A
melody will sound and the screen will go blank.
Note: To save battery power, the camcorder will auto standby after a
period of inactivity (60 seconds approximately). Press the Power button
(3) to reactivate the camcorder. You can change the auto power - off
time by setting the function "Auto Power Off" (see the "Setup" section).
INSTALLING A MEMORY CARD
To store pictures or videos, you need to insert a micro SD card (not
included) into your digital camcorder so you can save your files.
To insert the memory card:
1. Turn off the camcorder.
2. Open the rubber cover that protects the micro SD card slot.
3. Insert the micro SD card carefully into the micro SD card slot and
push firmly until you hear a "click" sound.
4. Turn the camcorder on.
5. To remove the card, push it in slightly to release it from the slot.
Notes:
• Always turn the camcorder off when you insert or remove the micro
SD card.
• To save your videos, we recommend that you purchase a micro SD
card that has good quality and sufficient capacity.
19
26/06/2014 1:56 PM