Control Panel - Teesa Cool Touch P700 Manuel D'utilisation

Owner's manual
7
OPERATION
Find proper location for the device: flat and stable surface, with enough space around to
allow free circulation.
Connect the device to power mains. Device issues a beep and power indicator lights up.
Device enters standby mode.
1. IR sensor: Always point the IR sensor of the remote control towards control panel of the
device.
2. ON/OFF button: Press this button to turn on/off the device.
3. SPEED button: Press this button to switch between 3 available fan speed settings: low,
medium and high. Corresponding indicator will light up next to the selected setting.
4. MODE button: Press this button to switch between 3 available operation modes: normal,
nature and sleep. Corresponding indicator will light up next to the selected setting.
5. TIMER button: Press this button to set the device to turn off automatically after preset
time within the range from 1 to 7 hours. Timer increases by 1 hour with each press of the
button. Corresponding indicator will light up next to the selected setting. When set time
is up, the device will turn off automatically.
6. SWING button: Press this button to turn on oscillation function (LED indicator lights up).
Press again to turn off this function (LED goes off ).
7. COOLER button: Press this button to turn on cooling function (LED indicator lights up).
Press this button again to turn off this function (LED goes off ).

CONTROL PANEL

6 5 4
1
3 2
19
EN