Cooling Function; Important - Teesa Cool Touch P700 Manuel D'utilisation

18
This device can be used as a classic fan or as an air cooler. When cooling function is on, water
pump will take the water from the water tank and pour it onto the paper filter. Paper filter
absorbs the temperature of the water and the evaporated air is blown out with the help of
fan.
Prior to use, make sure the filters are properly mounted, then fill the water tank with water
and press the COOLER button.
Filling water tank
It is necessary to fill the water tank with water if you want to use cooler function. If water
level is below the MIN marking or there is no water in the water tank it is forbidden
to turn on the cooler function. Activating cooler function with insufficient amount of
water may cause malfunction of the water pump.
1. Turn the water tank lock to horizontal position and slide out the water tank.
2. Pour only clean water to the water tank. When filling the water tank please keep observing
water level indicator on the water tank. Make sure to pass MIN marking but do not fill in
more than MAX marking.
3. When water tank is filled with proper amount of water, slide the water tank back in and
close the lock.
EN

Important:

• When water tank is filled with water, make sure not to lean it or bump into it as to avoid
leaks and damaging the device.
• Check water level in the water tank regularly when cooling function is on. If the water
level is low and drops down to MIN marking, pour more water. Always make sure there is
enough water inside the water tank.
• It is recommended to replace water at least once a week.
• Water tank must be filled only with clean water.
Ice boxes
In order to increase cooling effect, use ice boxes which are supplied with the unit.
1. Prior to use, fill the ice boxes with water, screw the cap back on and shake the ice box.
Then place the ice boxes in the freezing compartment of your refrigerator for a few hours.
When they have frozen successfully, take them out of the refrigerator.
2. Slide out the water tank and put ice boxes inside.
3. Pour water into the water tank up to the MAX marking.
• Be sure to first put the ice boxes inside the water tank, and then fill in water.

COOLING FUNCTION

Owner's manual