Battery Charge Indicator - Bosch GLI 18V-300 Professional Notice Originale

Assembly
Battery Charging (Accessory)
Use only the chargers listed in the technical data. Only these chargers are matched
u
to the lithium-ion battery of your power tool.
Note: The battery is supplied partially charged. To ensure full battery capacity, fully
charge the battery in the charger before using your tool for the first time.
The lithium-ion battery can be charged at any time without reducing its service life. Inter-
rupting the charging process does not damage the battery.
The lithium-ion battery is protected against deep discharge by the Electronic Cell Protec-
tion (ECP). A protective circuit switches the cordless worklight off when the battery is
drained.
Do not continue to press the On/Off switch after the worklight has been auto-
u
matically switched off. The battery can be damaged. Ensure that the battery is
charged and that the worklight has cooled before switching on the worklight again.
To remove the battery (1), press the release button (2) and pull the battery out of the
cordless worklight. Do not use force to do this.
Follow the instructions on correct disposal.

Battery charge indicator

The green LEDs on the battery charge indicator indicate the state of charge of the bat-
tery. For safety reasons, it is only possible to check the state of charge when the power
tool is not in operation.
Press the button for the battery charge indicator or
This is also possible when the battery is removed.
If no LED lights up after pressing the button for the battery charge indicator, then the
battery is defective and must be replaced.
Battery model GBA 18V...
LEDs
3× continuous green light
2× continuous green light
1× continuous green light
Bosch Power Tools
English | 15
to show the state of charge.
Capacity
60−100 %
30−60 %
5−30 %
1 609 92A 5X5 | (17.06.2021)