Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6.
Press <ENTER> and use <UP> or <DOWN> to set the strobe effect
7.
Finally, press <ENTER> to confirm. Note that you will have selected the first colour. Simply press
<MENU> to exit.
Dimmer speed setting
1.
Press <MENU> until
2.
Press <ENTER> to confirm your selection.
3.
Use <UP> or <DOWN> to select the desired dimmer speed (
4.
Press <ENTER> to confirm your selection.
7.4
DMX Mode
This mode allows you to control the fixture by any universal DMX controller.
•
All DMX-controlled devices need a digital start address so that the correct device responds to the
signals. This digital start address is the channel number from which the device starts to "listen" to
the DMX controller. The same starting address can be used for a whole group of devices or an
individual address can be set for every device.
•
When all devices have the same address, all the units will "listen" to the control signal on one
particular channel. In other words: changing the settings of one channel will affect all devices
simultaneously. If you set individual addresses, each device will "listen" to a separate channel
number. Changing the settings of one channel will only affect the device in question.
In case of the 3-channel LX101, you will have to set the start address of the first unit to 1
o
(CH1~3), the second unit to 4 (1 + 3) (CH4~6), the third to 7 (4 + 3) (CH7~9), and so on.
In case of the 4-channel LX101, you will have to set the start address of the first unit to 1
o
(CH1~4), the second unit to 5 (1 + 4) (CH5~8), the third to 9 (5 + 4) (CH9~12), and so on.
In case of the 9-channel LX101, you will have to set the start address of the first unit to 1
o
(CH1~9), the second unit to 10 (1 + 9) (CH10~18), the third to 19 (10 + 9) (CH19~27), and
so on.
1.
Press <MENU> until
2.
Press <ENTER> to confirm your selection.
3.
Use <UP> or <DOWN> to set the number of DMX channels (
4.
Press <MENU> until
5.
Press <ENTER> to confirm your selection.
6.
Use <UP> or <DOWN> to select the desired DMX starting address (
DMX Channel Values
9-Channel Mode
channel
function
1
master dimmer
2
red
3
green
4
blue
5
colour macros
V. 01 – 06/06/2012
LX101
is displayed.
is displayed.
is displayed.
from
to
description
000
255
0 ~ 100%
0 ~ 100%
000
255
(or step time for auto program)
0 ~ 100%
000
255
(or fade time for auto program)
000
255
0 ~ 100%
000
010
no function
red
011
255
100%
031
050
051
070
0%
071
090
0%
091
110
111
130
100%
131
150
100%
151
170
171
200
100%
7
(off) ~
,
~
,
or
~
green
blue
0%
100%
0%
100%
100%
0%
100%
0%
100%
100%
100%
©Velleman nv
(max.).
).
)
).
Publicité
Table des Matières
