Getting Started - EDNord GBC DOCUBIND TL200 Manuel D'utilisation

DOCUBINDTL200
Thank you for purchasing the GBC DocuBind TL200. This system features our wire holder design that
enables you to assemble your document as you punch, making it easier to load paper onto the twin
loop wire than previous systems! The DocuBind TL200 advanced punching technology also makes it
easier to punch more paper at once while providing greater reliability.
General safeguards
• Use the DocuBind TL200 only for its intended purpose of
punching and binding paper and covers according to the
indicated specifications.
• Do not place anything in the punch opening of the machine
other than paper and cover stock.

Getting started

1 Push the handle (A) onto the punching shaft located on the
right side of the machine (see figure 1.). Align the flat spot
of the handle with the flat of the shaft.
Secure handle with screwdriver.
2
3 Insert U shaped wire support bracket into holes on top rear
of machine.
Determine wire size
Slide the Binder Sizer open (C) (see figure 1).
1
Place document including covers behind Binder Sizer.
2
Release the Binder Sizer and select the wire binding
3
element that corresponds with the size shown by guide.
For best results, always use GBC brand covers with GBC
colour-coordinated wire.
Punching paper (see figure 2)
1 Align sheets or covers and insert edge to be bound into
punch throat (D1).
Jog the sheets until they are flush against the edge guide
2
and the bottom of the punch throat. Allow the paper to rest
against the Paper Support, or, you may prefer to hold the
sheets in place with one hand.
3 To punch, pull the Handle (A) towards you. Pull all the
way down to punch completely through the paper. Punches
up to 20 sheets of 20 lb./80 gram paper at once. Punch
only TWO clear covers at a time to prevent jams and
excessive wear.
EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500
• Place unit on a secure, stable work area to prevent the
machine falling and possibly causing personal injury and
damage to the unit.
• Follow all warnings and instructions marked on the product.
• Lift the machine from the bottom, not the cover.
• Do not lift the machine by the cover or paper holder wire.
Determine sheet width
1 Set Edge Guide (B) to paper size you wish to bind (11",
8-1/2" letter size, 11-1/4" oversized cover, A4 ring, A5,
Japan A4) (see figure 1). When using oversized covers, set
the Edge Guide on Covers, punch all of the covers for your
job and set aside. Move the Edge Guide back to the 11"
setting to punch your contents then bind.
Using the dial (E) (see figure 1) on the left side adjust the
4
Wire Crimper to correspond with the wire element size to
be used (see figure 1 inset).
4 Disengageable punching dies: If you require to punch A5,
a die can be disengaged from the punch by pulling up the
selector pin situated under the lid on top of the machine
(D), when selector is down the the punching die is
engaged, once again.
Margin Adjustment: The width of the margin between
5
the punched holes and the paper edge, can be adjustered,
depending on the thickness of the document. Adjust the
lever, situated on the left side of the TL200, by pulling it
out or pushing it in, according to the required margin
thickness.