emerio MIS-123774.1 Mode D'emploi page 5

MIS-123774.1
PARTS DESCRIPTION & ASSEMBLY

Before use, please check the four casters (1) are already installed onto the standing base (2) firmly.

Insert the motor unit (3) into the main body (4). Fix with the screw (5) on the back.

Loosen the plastic fastening screw (6) and the four pieces of M5*20 screws (7) with washers (8) on the
bottom of the main body.

Insert the main body into the standing base. Fix with the plastic fastening screw and the M5*20 screws
with washers.

Loosen the fastening screw (9) on the motor shaft (10). Attach the rear fan guard (11) onto the motor shaft.
Make sure the guard fits properly. Tighten back the fastening screw.

Remove the protection sleeve from the motor shaft. Insert the fan blade (12) onto the motor shaft. Tighten
the blade screw (13) to secure the fan blade.

Hook the front fan guard (14) onto the rear fan guard. Fix with the clasp (15) and then secure with the
screw (16).

Insert the hose (17) into the hole on the main body.

Remote control (18) can be stored on the top of the main body.
- 4 -
EN