Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
Problem
The brewing unit
cannot be opened.
Water is dripping
from the brewing
unit.
The quality of
the crema has
deteriorated.
On the surface
below the cup
stand there is
water.
The beverage
quantity does
not meet your
requirements.
C12_TAS100_TEXT_GBCH_8001224680.indb 5
C12_TAS100_TEXT_GBCH_8001224680.indb 5
Cause
The brewing unit is still
locked.
The T DISC is damaged or
leaky.
The T DISC has not been
pierced correctly.
The piercing unit has not
been inserted correctly.
The beverage outlet is sticky
or dirty.
Build-up of limescale in the
appliance.
This is condensation.
The T DISC bar code provides
the recommended volume for
every beverage selected. This
volume can also be adapted
to personal requirements.
Build-up of limescale in
the appliance could cause
reduced quantity.
Not enough water in the
water tank.
Solution
Only open the brewing unit when the
status display has stopped flashing and
remains lit continuously.
Unplug the mains plug. If the brewing
unit stays locked, contact the TASSIMO
careline.
Do not use T DISCs that are damaged.
Only use each T DISC once.
Wait until the brewing stage has come to
an end and the appliance has cooled down.
Remove the T DISC and clean the brewing
unit. Please refer here to the section
Cleaning.
Press the piercing unit into its holder using
both thumbs (until an audible click is
heard).
Clean the beverage outlet. Please refer
here to the section Cleaning.
Clean the brewing unit with the orange
Service T DISC. Please refer here to the
section Cleaning.
Descale the appliance. Please refer here
to the section Descaling. Do not use
descaling agent with phosphoric acid.
Condensation may appear and is not
caused by any fault with the appliance.
Wipe the water away with a cloth.
Reduced quantity:
During the brewing process, press the
Start / Stop button to interrupt this stage.
Increased quantity:
Press and hold the Start / Stop button until
the required beverage quantity has been
reached.
Descale the appliance. Please refer here
to the section Descaling. Do not use
descaling agent with phosphoric acid.
Fill up the tank after making a drink and
press the Start / Stop button. Your drink
will then be brewed ready for you.
5 en
22.06.2021 10:02:00
22.06.2021 10:02:00
Publicité
Table des Matières
