ARTHUR MARTIN ANN2842ACW Notice D'utilisation page 16

16
Problem
The compressor does not
start immediately after
pressing the "FastFreeze" or
"Shopping", or after chang‐
ing the temperature.
Water flows on the rear
plate of the refrigerator.
Water flows inside the refrig‐
erator.
Water flows on the floor.
Temperature cannot be set.
DEMO appears on the dis‐
play.
The temperature in the ap‐
pliance is too low/too high.
Possible cause
This is normal, no error
has occurred.
During the automatic de‐
frosting process, frost
melts on the rear plate.
Food products prevent the
water to flow into the wa‐
ter collector.
The water outlet is clog‐
ged.
The melting water outlet is
not connected to the evap‐
orative tray above the
compressor.
The "FastFreeze function"
or "Shopping function" is
switched on.
The appliance is in dem‐
onstration mode.
The temperature regulator
is not set correctly.
The door is not closed cor‐
rectly.
The food products' tem‐
perature is too high.
Many food products are
stored at the same time.
The door has been
opened often.
Solution
The compressor starts after a
period of time.
This is correct.
Make sure that food products
do not touch the rear plate.
Clean the water outlet.
Attach the melting water outlet
to the evaporative tray.
Switch off "FastFreeze func‐
tion" or "Shopping function"
manually, or wait until the
function resets automatically
to set the temperature. Refer
to "FastFreeze function" or
"Shopping function".
Keep the Mode pressed for
approximately 10 seconds un‐
til a long sound is heard and
display shuts off for a short
time.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door".
Let the food products temper‐
ature decrease to room tem‐
perature before storage.
Add less food products at the
same time.
Open the door only if necessa‐
ry.