Block Function - THOMSON WFIT6012I Manuel D'installation Et D'utilisation

STARTING UP AND
6
BLOCK FUNCTION SELECTION
Start/Stop button
a To start up the washing machine you
have to press the Start/Stop button.
The minutes remaining until the end of
washing and drying will appear on the
display at all times.
Block function selection
The lock function ensures that the programme
will not be affected if any buttons are pressed.
It is used when children could press the
buttons, etc.
The block function should be activated after
the wash programme has been selected
together with all its options.
Activating the block function
a The block function is activated by
pressing the Start/Stop button and
holding it down for at least 3 seconds.
The display will show if it is activated.
Deactivating the block function
b The block function is cancelled when
the wash programme comes to an end.
If you want to deactivate the block
function before the end of the
programme, you have to hold the start
button down again for at least 3 seconds.
After 3 seconds, the block function
indicator will disappear from the display,
and it will go into pause status.
The Start/Stop button does not cancel
the block function.
using the appliance and practical tips
STARTING UP

BLOCK FUNCTION

a
a
b
18