Troubleshooting Guide; After-Sales Services - Whirlpool AMW 509/IX Guide D'utilisation Et D'entretien

AFTER USE
The appliance does not work
• The turntable support is in place.
• The door is properly closed.
• Check the fuses and ensure that there is power
available.
• Check that the appliance has ample ventilation.
Wait for 10 minutes, then try to operate the
appliance once more.
• Open and then close the door before you try
again.
• Disconnect the appliance from the power
supply. Wait for 10 minutes before reconnecting
and trying again.
Before calling the After-Sales Service
1. See if you can solve the problem yourself with
the help of the suggestions given in the

"Troubleshooting guide".

2. Switch the appliance off and back on again to
see if the fault persists.
If the above checks have been carried out and
the fault still occurs, get in touch with the
nearest After-Sales Service.
Always specify:
• a brief description of the fault;
• the type and exact model of the appliance;
• the service number (number after the word
"Service" on the rating plate), located on the
right-hand edge of the appliance cavity (visible
when the appliance door is open).
- This appliance is manufactured with recyclable or reusable materials. Scrap the appliance in accordance
with local regulations on waste disposal. Before scrapping, cut off the power cords so that the
appliances cannot be connected to the mains.
- For further information on the treatment, recovery and recycling of household electrical appliances,
contact a competent local authority, the collection service for household waste or the store where the
appliance is purchased.
TROUBLESHOOTING GUIDE

AFTER-SALES SERVICES

SCRAPPING OF HOUSEHOLD APPLIANCES
The electronic programmer does not work
If the display shows the letter "F" followed by a
number, contact the nearest After-Sales Service.
In this case, quote the number that follows the
letter "F".
The service number is also indicated in the
guarantee booklet.
• your full address;
• your telephone number.
NOTE: if any repairs are required, please contact an
authorized After-sales Service (to guarantee that
original spare parts will be used and repairs carried
out correctly).
EN 21