EMAK IC2050 Manuel D'utilisation Et D'entretien page 39

chemicals used. Do not operate the appliance near people, unless they are also wearing
protective clothing, or animals.
• High-pressure jets of water can be dangerous if they are not used properly. Do not point the
jet in the direction of people, animals, and energized electrical appliances or towards the
appliance itself.
• Do not point the jet towards oneself or other people in order to clean off clothing or
footwear.
• Do not point the high-pressure jet towards materials containing asbestos or other harmful
substances
• Hold the spray gun firmly during use because the operator is subjected to the backlash of the
high-pressure jet when the control lever is operated to spray the product.
• Do not use the appliance in the rain.
• Pay particular attention to the instructions in the "Controls and connection to mains
electricity" section.
• Follow the instructions in the "Switching off" section:
- when the appliance is not is use;
- before leaving the appliance unattended, even for a short time;
- before topping up the chemicals;
- after use;
• Do not remove the plug from the power outlet by pulling on the power supply cable.
• Keep the power supply cable, any extension cords, the plugs and the outlets dry. Do not touch
them with wet hands.
• Should the power supply cable be damaged, contact a Qualified Electrician for its
replacement.
• Do not cover the appliance during operation and do not put it where there is inadequate
ventilation.
• When the appliance is used in enclosed spaces, make sure that there is adequate ventilation.
The appliance must not be used in enclosed spaces if it is operated with a combustion
engine.
• Do not get close to moving parts on the appliance, even if there are suitable devices for
protection.
• Do not remove the protective devices from moving parts.
• Do not tamper with hoses containing pressurised liquids.
• Do not carry out maintenance on the appliance when it is operating.
• Follow the instructions in the "DESIGNATED USE" section;
• Do not alter the appliance's installation conditions: it is especially important not to alter its
assembly and hydraulic connections.
• Do not operate any taps mounted on the appliance unless they are connected to a utility that
prevents the pumped liquid being released by accident.
• Do not neutralise or tamper with the safety controls and devices and the pressure limit/
adjustment valve.
• Operating pressure must never exceed the maximum amount specified for the appliance (also
refer to the "FEATURES AND TECHNICAL SPECIFICATIONS" section).
a) Unroll the delivery hose (1) completely.
b) Check that the adjuster (24) for the lance (13) is turned completely towards "S" so that
the lever (26) can be put in the "OFF" position. Put the tap lever (41), if any, in the "OFF"
position.
c) Check that there is no pressure in the delivery hose as follows.
- operate lever (30) and put it into the "BY-PASS" position.
d) Start up the appliance so it can prime. If the appliance is fitted with an electric motor, operate
40