Declaration Of Conformity; Environmental Protection; Service And Maintenance - Carat BS-1252 Manuel D'utilisation

Masquer les pouces Voir aussi pour BS-1252:

Mode d'emploi (35 pages)

Table des Matières

Les langues disponibles

Move the power tool with a circular motion or alternately in

length and crosswise direction over the work piece/surface

applying moderate pressure. When the rotational speed

drops, apply less pressure. Make sure the power tool rea-

ches its maximum no-load speed before it makes contact

with the surface again.

The guard and extraction hood is equipped with a remova-

ble forebody [2]. Especially to grind the ﬂ oor near to walls.

Only remove the forebody in exceptional situations. Wit-

hout the forebody the operator isn't fully protected against

ﬂ ying fragments and the rotating diamond grinding tool.

Avoid any contact with the diamond grinding tool. A dis-

mounted forebody increases the risk of the diamond grin-

ding tool contacting limbs, clothing and cables.

Pull the mains plug of the power tool from the socket,

before any dismounting or mounting the forebody of the

guard and extraction hood!

Dismount the forebody by pressing the locking and moving

the forebody in the stated direction.

Mount the forebody by pushing it to its original position.

EMISSION

Vibration emission value ah = 5 m/s².

Uncertainty K < 1.5 m/s².

Typically the A-weighted noise levels of the pro-

duct are: Sound pressure level 88 dB(A); Sound

power level 99 dB(A). Uncertainty K=3 dB.

Measured values determined according to EN 60745.

ENVIRONMENTAL PROTECTION

According to the European regulation 2012/19/

EU, CARAT is responsible to recycle old electric

drill motors.

You are therefore requested to return old

CARAT electric drill motors to your local reseller.

SERVICE AND MAINTENANCE

Pull the mains plug of the power tool from the

socket, before any work on the machine itself!

For safe and proper working, always keep the machine

and ventilation slots clean.

A blunt diamond grinding tool can be reground by brieﬂ y

grinding abrasive material (e.g. lime-sand brick).

ENGLISH – ORIGINAL INSTRUCTIONS

Changing the Brush Collar

To ensure optimal dust extraction, directly change a worn

brush collar [3].

Pull the brush collar (if necessary with aid of a screwdriver)

gently out of the housing of the guard and extraction hood.

Push a new brush collar carefully into the housing, rea-

ching the full depth. Make sure the brush collar doesn't

extends the guard and extraction hood, so the forebody

can be dismounted and mounted without problems.

WARRANTY

For the machine, a guarantee period of 12 months applies

from the moment of delivery. Guarantee claims must be

shown by submission of purchase invoice. The guarantee

includes the repair of defects which have occurred and can

be linked by to material or manufacturing faults.

Not covered by guarantee:

• Defects or damages which have arisen due to incorrect

use or connection.

• Machine overload.

• When maintenance has been carried out incorrectly or

badly.

• Information in the manual has not been properly followed.

• The machine is used by unqualiﬁ ed persons.

• If the machine is used for purposes for which it is

unsuitable.

• The machine is repaired using unoriginal parts.

• If the machine encryption is damaged or deleted.

• If defects are caused by ﬁ re, damp and/or transport.