Cleaning The Filter Screen; Cleaning Airless Spray Gun - Titan IMPACT 1040T Mode D'emploi

IMPACT 1040T
6.4

CLEANING THE FILTER SCREEN

A clean filter screen always guarantees maximum
i
feed quantity, constant spraying pressure and
problem-free functioning of the unit.
1. The filter screen will clog and must be cleaned at least
once a day.
2. Remove the retaining ring (Fig. 10, item 1) from the foot
valve housing (2).
3. Remove the inlet screen (3) from the foot valve housing
(2).
4. Clean thoroughly with the appropriate solvent.
6.5
i
1. Rinse airless spray gun with an appropriate cleaning agent.
2. Clean tip thoroughly with appropriate cleaning agent so
3. Thoroughly clean the outside of the airless spray gun.
INTAKE FILTER IN AIRLESS SPRAY GUN (FIG. 11)
i
Removal
1. Pull trigger guard (1) forward firmly.
2
2. Screw handle (2) out of the gun housing. Remove intake
3. Intake filter congested or defective – replace.
3
Replacement
1. Place intake filter (3) with the long cone into the gun
1
2. Screw handle (2) into the gun housing and tight en.
3. Snap in trigger guard (1).

CLEANING AIRLESS SPRAY GUN

Clean the spray gun after each use.
that no coating material residue remains.
Follow these steps if you used an accessory filter
(sold separately) for the spray gun.
filter (3).
housing.
1
CLEANUP
3
2
17