Charging Without Charging Unit; Placing The Charging Unit - Vorwerk VC100 Mode D'emploi

Fig. 2.3 Opening the charging unit
Fig. 2.4 Charging without charging unit
4
Fig. 2.5 Hanging up the charging unit
Preparation
2.1.2

Charging without charging unit

• Ensure that the Tabletop vacuum cleaner is switched off.
• Press the pin on the charging unit to open it.
• Insert the small plug of the mains charger in the corresponding socket on the
handle of the Tabletop vacuum cleaner.
• Then insert the mains charger into the socket.
The function indicator shows that the Tabletop vacuum cleaner is being charged.
The function indicator goes off as soon as the batteries are fully charged (after
approx. 4 hours). To achieve optimum charging, the Tabletop vacuum cleaner
must be charged until the function indicator goes off.
2.2

Placing the charging unit

Select the fastening material in accordance with the properties of your
wall.
• You need a screw to mount the charging unit
• Fasten the screw to the wall.
4 Ensure that the distance to the fl oor is at least 50 cm.
• Place the charging unit with the intended opening on the hook or screw.
You can also place the charging unit on an even surface (e.g., table or worktop).

to the wall.
11
EN