Télécharger Imprimer la page

Lamello Tanga DX200 Notice D'utilisation Originale page 40

Publicité

Applications
Corner cutting
1. Unplug the power cable
2. Release the base plate cover locking
mechanism using the tool set
3. Pull the base plate cover forward and
remove
4. Rotate the base plate cover 180° and
push slide it back on from the until it
locks
5. Connect the mains plug
6. Secure the attachable dust cover
7. To adjust cutting depth – for tools with
a diameter of 200 mm: Align the depth
adjuster with front edge (a) – for tools
with a diameter of 180 mm: Align the
depth adjuster with the rear edge (b)
8. Place the tool securely on the workpiece
9. Slowly plunge the machine
Attention: Corner cuts may only be
performed with the attachable dust cover
attached.
1.
3.
5.
7.
(b)
(a)
40
2.
4.
6.
8.
9.
El uso
Corte en ángulo
1. Saque el enchufe de la red
2. Aflojar el cierre para la placa de fondo
con el juego de herramientas.
3. Retirar la placa de fondo hacia delante
4. Girar la placa de fondo 180° y mover
desde detrás hacia el cierre
5. Conectar a la corriente
6. Sujetar el componente de protección
contra el polvo
7. Ajustar la profundidad de corte – para
herramientas con diámetro de 200 mm:
Alinear el ajuste de profundidad con el
canto delantero (a) – para herramien-
tas con diámetro de 180 mm: Alinear
el ajuste de profundidad con el canto
trasero (b)
8. Colocar el aparato en la pieza de trabajo
y elegir una posibilidad de tope segura
9. Mover lentamente la máquina
Atención: El corte en ángulo solo
se puede realizar con el componente de
protección contra el polvo encajado.

Publicité

loading

Produits Connexes pour Lamello Tanga DX200