Use - Maxx-world PC105 Mode D'emploi

EN
Use with Citrus Press

Use

CAUTION!
■ Keep children away from the device and accessories during operation.
■ Before use check that all accessories are fi tted correctly into place.
■ Do not reach into the feed chute, the rotating cutting insert or the citrus press during
operation.
■ Keep hair, jewellery and clothing away from rotating parts of the device.
■ Make sure that the device remains stable during operation. Always hold the motor
unit fi rmly with one hand.
■ The device must not be transported while it is switched on.
■ Do not force food into the feed chute.
■ In order to avoid overheating, do not leave the device switched on without interruption
for longer than 2 minutes. Allow the device to cool down for a short time before using
it again.
■ Always switch off the device and disconnect it from the mains power before inserting
or removing accessories.
To detach the protective cap with outlet (14) again, turn it anti-
clockwise and remove it. The screw conveyor (13) can then be
removed from the receptacle for the screw conveyor (15).
4. Insert the sorbet maker (2) into the device:
a. Hold it tilted slightly to the left and insert it into the motor
unit (6).
b. Turn it to the right until it audibly engages.
To release the sorbet maker (2), turn it to the left and detach it
from the motor unit (6).
1. Insert the collecting container (7) into the device and turn it
clockwise to secure it. When you do this, make sure that the
locking lugs engage.
To remove the collecting container (7) again, turn it anticlock-
wise and remove it.
2. Place the citrus press (5) onto the collecting container (7).
Make sure when you do this that it is seated correctly on the
motor shaft (11).
To remove the citrus press (5) again, simply pull it out.
20