OK. OWR 220-W Mode D'emploi page 15

Size - A5
• If the supply cord is damaged, it must be replaced by the manufacturer or its service
agent or similarly qualified person in order to avoid hazard.
• Regularly check if the supply cord, product or extension cable is defective. If found
defective, do not put the product into operation. Immediately pull the plug.
• Place the supply cord and, if necessary, an appropriate extension cable in such away
that pulling or tripping over it is impossible. Do not allow the supply cord to hang
down within easy reach.
• Do not jam, bend or pull the supply cord over sharp edges.
• The power plug is used as the disconnect device; the disconnect device shall remain
readily operable. To completely disconnect the power input, disconnect the mains
plug.
• The product may not function properly or not react to the operation of any control
due to electrostatic discharge. Switch off and disconnect the product; reconnect
after a few seconds.
• Protect the supply cord from being walked on or pinched particularly at the plug,
convenience receptacles and the point where it exits from the product.
• Never pull the plug by the supply cord or with wet hands.
• Disconnect the power plug in case of faults during use, during lightening storms,
before cleaning and when not using the product for a longer period of time.
• Danger! Before cleaning, switch the product off and disconnect the power plug from
the socket.
• When the product has reached the end of its service life, make it defective by
disconnecting the plug from the socket and cutting the cord in two.
OWR220_A5_130717.indb 15
15
17/7/13 4:07 PM