Electrolux EWT 2852EWW Notice D'utilisation page 18

18 www.electrolux.com
First try to find a solution to the problem
(refer to the table). If not, contact the
Authorised Service Centre.
With some problems, the acoustic
signals operate. The red indicator
flashes and one of the indicators comes
on, to show an alarm code:
• - The appliance does not fill with
water properly.
• - The appliance does not drain the
water.
• - The appliance lid or drum doors
are open or not closed correctly.
Please check both!
13.2 Possible failures
Problem
The programme does
not start.
The appliance does not
fill with water properly.
The appliance does not
fill with water and drain
immediately.
• The indicator of button Start/Pause
Possible solution
• Make sure that the mains plug is connected to the
mains socket.
• Make sure that the appliance lid and drum doors are
closed properly.
• Make sure that there is not a damaged fuse in the fuse
box.
• Make sure that the Start/Pause has been pressed.
• If the delay start is set, cancel the setting or wait for the
end of countdown.
• Deactivate the Child Lock function if it is on.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not
too low. For this information, contact your local water
authority.
• Make sure that the water tap is not clogged.
• Make sure that the filters of the inlet hoses and the fil‐
ters of the valves are not clogged. Refer to "Care and
cleaning".
• Make sure that the inlet hose has no kinks or bends.
• Make sure that the connection of the water inlet hose is
correct.
• Make sure that the drain hose is in the correct position.
The hose may be too low. Refer to 'Installation instruc‐
tion'.
flashes in red 11 times and 1 (or 2 or
3) time(s) in yellow: the mains supply
is unstable. Wait until the mains
supply is stable and the appliance
automatically starts operating.
WARNING!
Deactivate the appliance
before you do the checks.