Antenna Connections - Sansui HDLCDVD225 Guide D'utilisation

Masquer les pouces Voir aussi pour HDLCDVD225:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

If you are using an indoor or outdoor antenna, follow the instructions below that correspond to your
antenna system. If you are using a Cable TV service, see page 14 for Cable TV connections.
Combination VHF/UHF Antenna (Single 75 ohm cable or 300 ohm twin-lead wire)
Antenna
Jack
75 ohm
Coaxial
Cable
Combination VHF/UHF Antenna (Separate VHF and UHF 300 ohm twin-lead wires)
Antenna
Jack
Combiner
UHF 300 ohm
300-75 ohm Matching Transformer
Separate VHF/UHF Antennas (75 ohm VHF cable and 300 ohm UHF twin-lead wires)
Antenna
Jack
Combiner
UHF 300 ohm
Antenna
Jack
300-75 ohm
Matching
Transformer
VHF 300 ohm
VHF 75 ohm

Antenna connections

Connect the 75 ohm cable from the combination
VHF/UHF antenna to the antenna jack.
If your combination VHF/UHF antenna has a 300
ohm twin-lead wire, the use of the 300-75 ohm
matching transformer may be necessary.
Connect the UHF 300 ohm twin-lead wire to
the Combiner (not supplied). Connect the VHF
300 ohm twin-lead wire to the 300-75 ohm
Matching Transformer. Attach the Transformer to
the Combiner, then attach the Combiner to the
Antenna Jack.
Connect the VHF 75 ohm cable and UHF 300 ohm
twin-lead wire to the Combiner (not supplied). Attach
the Combiner to the Antenna Jack.
13

Publicité

Chapitres

Table des Matières
loading

Table des Matières