Optional Settings; Manual Settings For Heater - Fronius Ohmpilot Instructions De Service

Optional settings

Manual settings
NOTE!
for HEATER 1
Settings not absolutely necessary.
The settings described here can be made for all the application examples shown above.
If they are not described for the respective example, they are not absolutely necessary.
Setting the output of HEATER 1 manually:
1
2
3
NOTE!
It is not possible to measure heating element 1 automatically.
In the case of applications with a 1-phase and a 3-phase heating element, it is not possi-
ble for the Ohmpilot to measure heating element 1 automatically due to the cabling. In
this case, the configuration must be carried out manually.
Activating legio- When the legionella prevention system is activated, the hot water is heated to 60 °C at a
nella prevention set interval.
108
Under HEATER 1, select "Manual"
Select "Single-phase" or "Three-phase" Consumer
Enter the output of the load