Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
KLR 200 Remote control
VELUX KLR 200 is a two-way remote control applying to the io-homecontrol
the WIC 01M. The procedure given here must be followed when setting up a WIC 01M for the first time using a new
remote control of the type VELUX KLR 200.
1.
Mount all actuators and sensors.
2.
Connect all cables.
3.
Connect mains supply to the WIC 01M you want to register.
•
WIC 01M is now in Auto set-up state and can be registered by the remote control.
4.
Follow the instruction for the KLR 200 for registration of the WIC 01M (new actuator / window).
When the WIC 01M has been registered previously, it is necessary to reset it, in order to register it again, please see
"Resetting".
Retrofitting of sun screen products
As soon as an unregistered sun screen product is connected to a WIC 01M and mains supply is connected, it will be
ready for registration. It will remain in this state for 10 minutes. The guide for connecting and setting up a sun screen
product is given below.
1.
Mount sun screen product if this is not already done.
2.
Disconnect mains supply to the WIC 01M in question.
3.
Connect all cables.
4.
Connect WIC 01M to mains supply.
5.
Follow the instruction for the KLR 200 for registration of sun screen products.
Resetting
Here the resetting procedure of the WIC 01M is described. This will not be necessary under normal circumstances.
1.
Press the program button on the WIC 01M shortly, this will close the window if it is open.
•
If the window is not completely closed, wait until it is before proceeding to step 2.
2.
Keep the program button down for 5-10 seconds until the window starts moving back and forth.
•
The actuator will now go back and forth for approximately 30 seconds. After this period the window will
move back to its closed position.
3.
Turn of the universal mains supply for the WIC 01M.
•
The WIC 01M is now reset and ready to be registered.
If both sun screen products and window actuators are connected, both products will be reset when following the above
described procedure.
®
standard and therefore it is compatible with
5
Publicité
Table des Matières
