Notices; Important Safety Instructions - Epson Stylus NX530 Guide Rapide

Masquer les pouces Voir aussi pour Stylus NX530:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Notices

Important Safety Instructions

Before using your Epson product, read and follow these safety instructions:
Be sure to follow all warnings and instructions marked on your Epson product.
Use only the type of power source indicated on the product label.
Use only the power cord that comes with the product. Use of another cord may cause fires or
shock. Do not use the cord with any other equipment.
Place the product near a wall outlet where the plug can be easily unplugged.
If you won't be using the product for a long period, unplug the power cord from the electrical
outlet.
Always turn off the product using the
turned off completely before unplugging the product or cutting off power to the electrical
outlet.
Avoid plugging the product into an outlet on the same circuit as a photo copier or air control
system that regularly switches on and off, or on an outlet controlled by a wall switch or timer.
Do not let the power cord become damaged or frayed.
If you use an extension cord with the product, make sure the total ampere rating of the devices
plugged into the extension cord does not exceed the cord's ampere rating. Also, make sure the
total ampere rating of all devices plugged into the wall outlet does not exceed the wall outlet's
ampere rating.
Place the product on a flat, stable surface that extends beyond its base in all directions. It will
not operate properly if it is tilted or at an angle.
Avoid placing the product in locations that are subject to rapid changes in heat or humidity,
shocks or vibrations, or dust.
Do not place or store the product outdoors or in locations with excessive water, high
temperature, or high humidity. Do not use with wet hands.
Leave enough room around the product for sufficient ventilation. Make sure the product is at
least 4 inches (10 cm) away from the wall.
Do not block or cover openings in the case or insert objects through the slots.
Do not place the product near a heat source, strong light source, or in direct sunlight.
Do not use aerosol products that contain flammable gases inside or around the product. Doing
so may cause fire.
Do not press too hard on the document table when placing the original.
Do not open the scanner section while the product is copying, printing, or scanning.
Do not touch the flat white cable inside the product.
Be careful not to trap your fingers when closing the document cover or scanner.
28
Notices
power button, and wait until the LCD screen has
P

Publicité

Table des Matières
loading

Table des Matières