Cleaning And Storage - CTC CLATRONIC BS 1240 Mode D'emploi & Garantie

GB
• Every third time the vacuum cleaner is emptied, or in the case of heavy
soiling, please clean the fi lters by allowing running water to fl ow through
the fi lter felt in the opposite direction to which the air passes through.
• The fi lters should only be reinserted when they are completely dry!
Important note!
• Cleaning may become necessary after a shorter time, depending on the
conditions of use, e.g. when vacuuming fi ne dust.
• If the suction power of your vacuum cleaner diminishes please clean the
fi lters as described.
• If the suction power suddenly diminishes during operation this may be due
to the fi lters being locked.
Possible cause: As the fi lters are blocked cooling air for the motor is drawn
through the secondary air valve (9). This occurs in order to protect the motor.
Switch the vacuum cleaner off. Clean the fi lters in soapy water as described
above.
The vacuum cleaner should only be switched on again when the fi lters are dry.
Cleaning
• Pull the plug out of the socket before cleaning!
• Clean the casing with a dry cloth.
• Clean the motor protection fi lter approximately every 3. time the vacuum clea-
ner is emptied. Clean the fi lter in hot water without additives. Put it back into
place only once it is completely dry.
Storage
• Wind the cable completely.
• Insert the hook of the nozzle on the bottom of the vacuum cleaner into the
parking assistance.
56
05-BS 1240 Neu 56
Remove the motor protection fi lter and
den exhaust fi lter. Clean the fi lters by
tapping out its contents and gentle
brushing.
In cases of heavy soiling: Wash both
fi lters in a weak soapy water solution,
rinse out and allow to dry.

Cleaning and storage

22.04.2005, 9:39:49 Uhr