Using The Appliance - CTC CLATRONIC BS 1240 Mode D'emploi & Garantie

1. Insert the vacuum hose in the opening in the dust bag compartment until it
locks in mechanically.
2. To release the hose, press the button on the vacuum hose.
3. Keep the button pressed and pull out the hose.
4. Insert the vacuum tube into the handle if required.
1. Fit on the accessory.
2. Unwind the necessary length of cable and insert the plug in a duly installed
230V/50Hz protective contact socket.
3. Set the vacuum power with the vacuum power regulator.
4. Vacuum at a steady speed. There is no need to exert pressure.
5. Attention: pay attention to the range that can be covered with the cable length.
Vacuum power regulator
Low vacuum power:
Medium vacuum power:
High vacuum power:
Cable winding device
Pull out the cable up to the maximum length indicated with the yellow mark. Never
pull the cable out up to the red mark as the cable winding can be damaged. Said
damages are not covered by the warranty.
Winding
Press the cable winding button and guide the cable. Hold the cable to avoid
wrapping.
Telescopic Suction Tube
1. This makes it possible to adapt the height to your individual body size. Unlock
the coupling by turning the wide section of the suction tube to the left.
2. Move the suction tube as required. To lock the coupling, turn the wide suction
tube to the right.
Nozzle accessories
Crevice nozzle /
brush nozzle:
05-BS 1240 Neu 53
Start-up

Using the Appliance

For curtains and delicate fabrics
For long-pile velour carpets and textile fl ooring
For sturdy rugs and fl oors
To vacuum corners and slits.
Please note that the crevice/brush nozzle is a „2 in 1"
attachment.
GB
53
22.04.2005, 9:39:47 Uhr