Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Adjusting the angle head
The angle head can be adjusted 360°(8 positions in
45-degree increments). To adjust it, loosen the hex bolt
and remove the angle head.
Adjust the angle head to the desired position and rein-
stall it so that the teeth on the housing will match up
with the grooves in the angle head. Then tighten the hex
bolt to secure the angle head.
2
► 1. Hex bolt 2. Angle head
► 1. Groove 2. Tooth
Straight head and ratchet head
(Accessory)
Straight heads and ratchet heads are available as
optional accessories for various applications on the job.
► 1. Straight head
1
1
2
1
7 ENGLISH
► 1. Ratchet head
OPERATION
CAUTION:
•
Always insert the battery cartridge all the way
until it locks in place. If you can see the red
indicator on the upper side of the button, it is
not locked completely. Insert it fully until the red
indicator cannot be seen. If not, it may acciden-
tally fall out of the tool, causing injury to you or
someone around you.
Hold the tool firmly and place the socket over the bolt or
nut. Turn the tool on and fasten for the proper fastening
time.
The proper fastening torque may differ depending upon
the kind or size of the bolt, the material of the workpiece
to be fastened, etc. The relation between fastening
torque and fastening time is shown in the figures.
1
Publicité
Table des Matières
