Tools And Accessories - Kress Elektrowerkzeuge 530FM Mode D'emploi Original

20 English
Grinding work
If the milling and grinding motor is used as a grind-
er in manual operation, it is important to ensure
EN
that the circumferential speed specified by the tool
manufacturer is not exceeded.
The peripheral (circumference) speed is calculat-
ed as follows:
d π n × ×
---------------------
V =
60000
V = Peripheral (circumference) speed
d = grinding tool Ø in mm
π
= 3.14
n = Idling speed of the milling and grinding motor
in revolutions/min.
Example: The grinding tool used has a diameter of
25 mm.
25 π 30000 × ×
------------------------------------
V =
60000
The accepted overspeed is not exceeded.
Make sure that
the grinding tool used is bound with ceramic
or resin.
the grinding tools are stored in such a way
that they are not damaged (cracks in the
grinding tool, damaged tool shanks and so
on, mean that the user's life is in danger).
before you use new grinding tools, you must
carry out a test run for at least 5 minutes with-
out the device being overloaded.
-NOTE-
Very high rotational speeds result in the tools
wearing rapidly and consequently in low service
lives for the tools!
-WARNING-
Only use sharp milling tools that are in good con-
dition! Preferably use our original milling tools.
When you use other milling tools, the steady rota-
tional speeds per minute indicated on the manu-
facturer's rotating tools must not be exceeded!
FME-EN / 1101
m
--- -
s
m m
= 39,75
--- - --- -
s s
Routing Procedure
Keep your hands away from the cutting area
and the cutting disc. Hold the auxiliary han-
dle with your second hand.
When both hands hold the machine, they
cannot beinjured by the cutting disc.
Apply the machine to the workpiece only
when switched on.
Otherwise there is danger of kickback when
the cutting tool jams in the workpiece.

5. Tools and accessories

Always wear a dust protection mask when
working with the power tool.
Do not attach a saw chain woodcarv-
ing blade or toothed saw blade.
Such blades create frequent kickback
and loss of control over the power
tool.
Permissible grinding tools
You can use all grinding tools shown in the illus-
trated instructions.
Observe the permissible speed and circumferen-
tial speed specified on the label of the grinding
tool.
The ratings on the type plate of the power tool
must not exceed the permissible speed [rpm] and
circumferential speed [m/s] of the grinding tools
used.
For safety reasons, the grinding tools must not be
operated at circumferential speeds exceeding 80
m/s.
When using grinding tools, always observe
the information provided by the grinding tool
manufacturer.
Tools and accessories