D-Link DAP-1320 Guide D'installation page 31

TROUBLESHOOTING
SETUP AND CONFIGURATION PROBLEMS
1. HOW DO I RESET MY DAP-1320 WIRELESS RANGE EXTENDER N300 TO FACTORY
DEFAULT SETTINGS?
- Ensure the product is powered on.
- Press and hold the reset button on the bottom of the device for 5 seconds.
Note: Resetting the product to the factory default will erase the current configuration
settings. The default Wi-Fi network name (SSID) and password are printed on
the D-Link DAP-1320 Wireless Range Extender N300's Wi-Fi Configuration
Card.
2. HOW DO I ADD A NEW WI-FI CLIENT OR PC IF I HAVE FORGOTTEN MY WI-FI NETWORK
NAME (SSID) OR WI-FI PASSWORD?
-If you haven't changed the extended Wi-Fi network's settings, you can use the
network name (SSID) and Wi-Fi password on the Wi-Fi Configuration Card.
- If you did change the network name (SSID) or Wi-Fi password and you did not record
this information on the Wi-Fi Configuration Card or somewhere else, you must reset
the device as described in Question 1 above.
- Make sure you write down these settings so that you can enter them into each
wirelessly connected PC. You can use the included Wi-Fi Configuration Card to
record this important information for future use.
TECHNISCHE ONDERSTEUNING
Technische ondereuning voor klanten in Nederland:
http://dlink.com / 0107994344 / €0.15per minuut.
Technische ondereuning voor klanten in België:
http://dlink.com / 033039971 / €0.175per minuut(spitsuren), €0.0875per minuut(daluren)
Technische ondereuning voor klanten in Luxemburg:
http://dlink.com / +32 70 66 06 40
DAP-1320
31