Temperature Monitoring; Setup Options - Festool SYSTILE KAL II Notice D'utilisation D'origine

GB
KAL II
LED orange
Power failure mode, see chapter 6.5.
6.2 On/Off switch [1-2]
The ON/OFF switch [1-2] has three set-
tings:
– Press once -> Switch on in lighting
mode in energy-saving stage (Stage
1: 30%)
– Press twice -> Switch to max. lumi-
nosity (Stage 2: 100%)
– Press three times -> switch off
6.3 Voltage monitoring
If the minimum operating voltage is not
met during lighting mode with either in-
ternal or external battery pack, the de-
vice shifts to emergency mode. It reduc-
es luminosity and switches off after 2
minutes.
6.4

Temperature monitoring

If the device temperature does not re-
main within the specified limits, the
working light switches to emergency
mode. It reduces luminosity and then
switches off after 2 minutes.
6.5 Power failure mode
The working light has a power failure
mode. It automatically lights up the work
area in the event of a sudden power fail-
ure.

Hold down the ON/OFF switch [1-2]
and insert the mains charging adapter
or car charging adapter in the connec-
tor socket [1-4].
14
The working light turns off and the
charging indicator switches to flashing
orange (charging) or continuous orange
(fully charged). depending on the operat-
ing state.
In the event of an interruption to the ex-
ternal voltage supply, the working light
automatically switches on.
Switching off the mode:

Press the ON/OFF switch [1-2] again.
Charging indicator switches to standard
mode, see
chapter 6.1
6.6 Operating with external Festool
battery pack [2A] + [2B]
The working light can operate with any
Festool battery pack from the BPC or
BPS series. When connected to the ex-
ternal Festool battery pack, the working
light only consumes power from this bat-
tery pack.

Only compatible Festool chargers
can charge the Festool battery
pack.
6.7

Setup options

Attachment handle [1-3]
The folding attachment handle allows
you to hang the device from scaffolding
or similar structures.

If you decide to power the device
with an external Festool battery
pack, the attachment handle must
be detached beforehand [2A].
Setup angle
The working light can be set up in three
different angles [3].
.