Installing & Replacing The Battery; Getting Started - König Electronic KN-WS700 Mode D'emploi

2. Installing & Replacing the Battery
Place the remote control face down, press down on the
ridged area of the battery cover and pull towards you to
remove the tray. Place one CR2025 lithium button-cell
battery on the tray with the positive "+" side facing you.
Reinsert the tray.

3. Getting Started

3.1 Insert the bracket into the slot of the digital photo frame and rotate the bracket clockwise. Please
make sure the stand is locked before putting it on the table steadily. Please refer to the illustration
below.
3.2 Put the digital photo frame with installed bracket in a flat position, then plug one end of the AC
adapter into a standard 110-240V AC electrical outlet and the other end into the DC IN slot on the
frame.
3.2 Remove the protective film covering on the LCD.
3.3 Remove the plastic battery insulator from the battery compartment and make sure the remote
control has a battery inside. Please refer to "Installing & Replacing Battery" if you need a new
battery.
3.4 Press the POWER Button on the remote control.
4. Operating Instruction
After turning on the unit, it will first show the startup logo, then
the main menu.
1. SD/MMC/MS/SDHC CARD
2. Earphone Jack
3. USB port
4. Mini-USB port
5. DC IN
4