Agri-Fab 45-0329 Notice D'utilisation page 7

18. Assemble the vinyl grip (U) onto the flow control arm.
See figure 7.
19. Insert the flow control arm down through the slot in
the flow control bracket. Assemble the small hole of
the flow control link (V) to the flow control arm using
a 1/4" x 3/4" hex bolt (D), a nylon washer (J) and a
1/4" hex lock nut (F) as shown in figure 7. Tighten
carefully. The flow control link should be snug but
should pivot with no more than slight resistance.
(V) FLOW
CONTROL
LINK
(small hole)
(F) 1/4" HEX
LOCK NUT
(J) NYLON
WASHER
(B) 1/4" x 3/4"
HEX BOLT
FIGURE 7
20. Assemble the flow control arm to the flow control
mounting bracket using a 1/4" x 3/4" hex bolt (D), two
nylon washers (J) and a 1/4" hex lock nut (F). Tighten
carefully. The flow control arm should be snug but
should pivot with no more than slight resistance. See
figure 8.
(F) 1/4" HEX
LOCK NUT
(J) NYLON
WASHERS - 2
FIGURE 8
(U) VINYL GRIP
(B) 1/4" x 3/4"
HEX BOLT
ENGLISH
21. Hook the double bent end of the flow control rod
through the hole in the slide gate bracket located
near the bottom of the hopper. See figure 9.
FIGURE 9
22. Place a 5/16" flat washer (K) onto the other end of the
flow control rod. Insert the end of the rod through the
curved slot in the flow control mounting bracket and
through the hole in the flow control link. Secure with
a 5/16" flat washer (K) and a 3/32" x 3/4" cotter pin
(M). See figure 10.
NOTE: You can leave off the second washer if there is
not enough room on the end of the rod.
FIGURE 10
23. Place the adjustable stop (S) into the "ON" end of the
slot in the top of the flow control mounting bracket.
Secure with the 1/4" x 3/4" carriage bolt (E), a nylon
washer (J), a 5/16" flat washer (K) and the nylon wing
nut (R). See figure 11.
7
(K) 5/16"
FLAT
WASHER
FLOW
CONTROL
ROD
(K) 5/16"
FLAT
(M) 3/32"
WASHER
COTTER PIN