Makita AT638A Mode D'emploi page 6

Air duster
CAUTION:
Do not aim the ejection port of the
air duster to someone. Also, keep your hands and
foot away from the ejection port. If the air duster
button is accidentally pushed, it may cause a per-
sonal injury.
CAUTION:
Always check your surroundings
before using the air duster. Blown dust or objects
may hit someone.
CAUTION:
Do not connect or disconnect the
air hose while pushing the air duster button.
The air supplied to the tool can also be used as an air
duster. You can clean the work area by pressing the
button on the grip end.
1
► 1. Button
NOTICE:
After using the air duster, the driving force
of the tool will temporarily decline. Wait until the air
pressure recovers in this case.
NOTICE:
Perform a test blow if you use the air
duster immediately after the oil was applied. The oil
may be sprayed with the air.
ASSEMBLY
CAUTION:
Before carrying out any work on
the tool, always return the trigger and disconnect
the air hose from the tool.
CAUTION:
Load the same type, size and
uniform length of staples when loading multiple
strips of staples in the magazine.
Loading stapler
NOTE: Always hold the rear of the sliding door when
you press the lever. The sliding door opens suddenly
with the lever pressed when staples are stored in the
magazine.
1. Press the lever and open the sliding door of the
magazine.
► 1. Lever 2. Sliding door
2. Insert a strip of staples into the opening of the
magazine all the way.
3. Close the sliding door until the sliding door is
locked.
Removing staples
To remove staples, follow the procedures of "Loading
stapler" in reverse.
Nose adapter
To prevent the surface of workpiece from being
scratched or damaged, use the nose adapter.
6 ENGLISH
2
1