Activated Carbon Filter; Cleaning The Fine Dust Particle Sensor; Cleaning The Housing; Storage - Beurer LR 310 Mode D'emploi

Activated carbon filter

IMPORTANT
The three-layered filter should be changed after 4320 operating hours (see "Filter change" section).
The three-layered filter cannot be washed.

8.2 Cleaning the fine dust particle sensor

The fine dust particle sensor should be cleaned every 2 months.
Note
If the air purifier is used in a dusty environment, it may need to be cleaned more often.
To clean the sensor, switch off the air purifier and pull the mains plug
out of the socket. Open the cover on the side of the housing, and
remove the cover.
Clean the sensor, along with the air inlet and outlet using a moiste-
ned cotton bud.
Afterwards, dry all of the cleaned parts using a dry cotton bud.
Attach the fine dust particle sensor cover again.

8.3 Cleaning the housing

Clean the housing of the air purifier with a damp cloth (water or a mild cleaning solution). When cleaning, do
not use any solvents or other aggressive or abrasive cleaning agents, as the surface may become damaged.

8.4 Storage

If you do not plan to use the device for a long period of time, we recommend that you clean it and store it in
the original packaging in a dry environment, ensuring it is not weighed down by additional items.
Front
HEPA filter H 13
20
Rear