Functions - Romus Rlm-70 Mode D'emploi

◦ Addition / Sustraction
Distance measuring.
LThe next measurement is added to the previous one, then press
second measured value is shown and the result is shown automatically.
The next measurement is subtracted from the previous one. Then press
the result is always shown in the summary line with the previous value in the
second line.
The last step is cancelled.
◦ Area measurement
Press once. The
the first length measurement (e.g. length). Press
length measurement (e.g. width). After taking the second measurement, the area
to take the second measurement, the area/ surface is automatically calculated
and displayed in the summary line.
The last indivual measured value is indicated at the second line in the display.
◦ Volume measuring
For volume measurements, push button
volume measurement appears in the display. Afterwards, press this button
to measure the lenght, press this button
the height.
After taking the third measurement, the volume is automatically calculated and
displayed. the last individual measured value is not displayed.
Indirect measurement determining a distance using 2 measurements
As shown is figure B, e.g. when measuring heights that require the measurement
of two or three measurements as following step :
Press this nutton
Aim at the upper point (1) and trigger the measurement. After the first measure-
ment the value in the symbol. Keep the instrument as horizontal as possible. The
tool default the measurement result as horizontal value.

Functions

symbol appears in the display. Press
three times, the display
www.romus.fr
again to take the second
twice until
for width, press button to
shows. The laser is switched on.
Réf. 93257
the
button to take
the indicator for
take
16