Switching On And Off; Cleaning And Maintenance - Toolland VL102 Mode D'emploi

5. Operation
5.1

Switching On and Off

1. Make sure the on-off switch is in the off position.
2. Plug the device to the mains.
3. Slide the on-off switch to the on position:
position I: 50 °C
o
position II: 600 °C
o
4. Switch the device to position I and let run for at least one minute before switching off.
5.2 Use as a Weed Burner
Nozzle Assembly
Slide the weed nozzle over the hot air nozzle.
Never touch the nozzle immediately after use. Risk of burn injuries!
Handle Assembly
Attach the handles on the device. The device may only be used with the handles attached.
Use
1. Switch on the device to position II. Allow the device to warm up for at least 45 seconds.
2. Hold the device at an angle of 45° away from the user.
3. Gently waft the nozzle approximately 5 seconds over the weed. Do not burn the plant completely, only the
heat is needed. Keep the nozzle at a distance of approximately 15 cm of the weed. Stronger weeds or
woody stems (wild grass, roots, etc.) may require a repeat application. If necessary, repeat this procedure
after a few days. Do not use this device on flower beds or lawns.
4. Switch off after use.
Notes
 Dry woods, leaves, pine needles and dry grasses may catch fire. Watch the treated plants for some time
after treatment.
 The best time to treat sprawl is in the spring. The results are not visible immediately.
 Older plants with hard leaves, such as thistles, dry earliest after repeated treatment at intervals of one to
two weeks. Some types of grasses are extremely robust and require a longer exposure to heat.
 The weed needs only be heated. Burning is not necessary. The cells of the leaves dry out in this way and
the weed dies.
 Certain weed species require repeated treatment.
6.

Cleaning and Maintenance

 Keep the ventilation openings clear, clean and dust-free at all times.
 If the device is running erratically or something unusual occurs during use, immediately switch off the
device and unplug from the mains. Inspect the device before using it again. Repair must only be carried out
by a qualified technician.
 If the supply cord is damaged, it must be replaced by a qualified technician.
 Wipe with a damp cloth to keep it looking new. Do not use harsh chemicals, cleaning solvents or strong
detergents.
 Clean the device and accessories before storing.
Storing
 Make sure the device has completely cooled down before storing.
 Store the device, its accessories and this user manual in the original packaging.
 Always store in a cool and dry place.
V. 02 – 17/11/2017
VL102
WARNING
5 ©Velleman nv