Velda 3000 Mode D'emploi page 14

!
le montage non conforme, le mauvais emploi, l'utilisation abusive ou le mauvais
entretien de la pompe.
!
les détériorations de la fiche ou du cordon électrique.
!
les détériorations des paliers ou du moteur consécutives à un fonctionnement à
vide de la pompe (c'est-à-dire sans passage d'eau).
!
les dommages causés par succion de sable et de pierres.
!
les détériorations ou le bris de la roue aubée.
GB
INSTRUCTIONS HIGH-STREAM POND PUMPS
3000 / 4500 / 6000 / 8000 / 12000 / 15000 / 20000 / 25000
GENERAL
The Velda High-Stream pond pumps are produced using the latest insights and
technical possibilities. They rank among the best pond pumps in the world. The
economical asynchronous motors combine high capacity and low energy con-
sumption. The motors are equipped with a thermal security device and are entirely
sealed watertight. Combined with ceramic bearings this guarantees longevity.
Owing to their high capacity, High-Stream pond pumps are pre-eminently suitable
for foam effect fountains, flows of water and waterfalls. The pumps can also be used
outside the pond, provided that they are placed lower than the water level. This
makes High-Stream pumps also ideal for pressure filters and larger filter installations.
USE AND SAFETY
Before connecting the pond pump and putting it to use, carefully read the present
instructions for use and safety regulations. The installation and use of the pumps
described here is only allowed for persons from 16 years old, of whom it can be
expected that for these persons the text is clear and understandable.
!
High-Stream pumps are provided with 10 m of grounded electrical safety cable
with flex and plug. Connection to a grounded receptacle with earth leakage circuit
breaker of 30 mA is necessary.
!
Only use good quality grounded extension leads, flexes, receptacles and the like.
!
The flex is watertight. It has an anchored pump housing and may not be replaced
when damaged. If any damage should occur to the flex, the pump may not be used.
!
When carrying out activities in or near the water, all devices that are immersed or
in touch with the pond should be de-energized.
!
Do not displace the pump by lifting it with the help of the flex. Fix an additional
wire to the pump housing to lift the pump out of the water.
!
Velda High-Stream pumps are exclusively made to displace water. This means that
transport of any different liquids explicitly excluded.
!
The use of these pumps in swimming pools is not allowed.
!
The pump should be installed at least 10 cm and at most 2 m below water level.
!
The pump should always be placed as level as possible and not in the bottom
sludge. If necessary, you should use an elevation, made from a number of stones.
!
The temperature of the water to be displaced may be maximum 35 °C.