Quick Adjustment; Measuring Carriage; Camera - KELCH KENOVA V224 BA Version 1.0 Manuel D'utilisation

4 Operation
4.2

Quick adjustment

To move an axis quickly, proceed as follows:

Hold the handle (2) firmly. The weight of the measuring carriage is compensated by
a compression spring. As a result, you do not require a lot of strength to maintain the
height when the brakes are released.

Unlock the X-Axis (–) and if necessary the Z-Axis (|) by pressing the buttons on the
handle (2).

Move the measuring carriage to the required position. This is generally the position
in which the edge of the tool can be seen on the devices display

Release the button(s) and then the handle.

When you release the buttons, the axis are immediately locked. You can use the
hand wheels to finely adjust the axis throughout the adjustment area.
4.3

Measuring Carriage

The measuring carriage has to be positioned that the cutting edge of the tool is between
the camera and the light source.
Operation of the control device is described in a separate manual.
4.4

Camera

The cameras measuring position is controlled using the screen at the control device.
When you select a measuring program, you only need to position the edge to be
measured in the display area, since the edges can be determined automatically by the
image processing software.
KENOVA set Line V224  Kelch GmbH 2013
Kelch GmbH • Werkstraße 30 • D-71384 Weinstadt-Endersbach • Tel. (+49)7151 20522 0 • Fax (+49)7151 20522 11 • info@kelchgmbh.de
1 Tool (not included)
2 Tool holder (adapter sleeve)
3 Measuring carriage
4 Light source
5 Handle
6 Quick adjustment for X und Z
7 Touchscreen display
Figure 6: Detailed view
Seite 17