Beta 601C Mode D'emploi page 7

INSTRUCTIONS FOR USE
OPERATION MANUAL AND INSTRUCTIONS FOR THE DIGITAL ANGLE INDICATOR MANUFACTURED BY:
BETA UTENSILI S.P.A.
Via A. Volta 18,
20845, Sovico (MB)
ITALIA
Original documentation drawn up in ITALIAN.
CAUTION
IMPORTANT! READ THIS MANUAL THOROUGHLY BEFORE USING THE DIGITAL ANGLE INDICATOR.
FAILURE TO COMPLY WITH THE SAFETY STANDARDS AND OPERATING INSTRUCTIONS MAY RESULT
IN SERIOUS INJURY.
Store the safety instructions with care and hand them over to the users.
PURPOSE OF USE
The digital angle indicator can be used for the following purpose:
• measuring the right-hand/left-hand torque angle on screws and nuts in combination with torque wrenches,
ratchets or levers.
The digital angle indicator must not be used for the following operations:
• must not be used in humid or wet environments, and must not be exposed to rain or snow
• must not come into contact with chemical and corrosive substances
• must not be used for any applications other than recommended ones.
WORK AREA SAFETY
Do not operate the digital angle indicator in environments containing potentially explosive atmospheres, because
sparks may be generated, which can ignite the dust or fumes.
Keep children and unauthorized personnel away from the digital angle indicator.
'R QRW XVH WKH GLJLWDO DQJOH LQGLFDWRU QHDU ÀDPPDEOH PDWHULDO
DIGITAL ANGLE INDICATOR SAFETY
Before use, check that the digital angle indicator has not been damaged, and that no parts are worn.
Do not force the electronic circuit of the digital angle indicator.
PERSONNEL SAFETY
6WD\ DOHUW ZDWFK ZKDW \RX DUH GRLQJ 'R QRW XVH WKH GLJLWDO DQJOH LQGLFDWRU ZKLOH WLUHG RU XQGHU WKH LQÀXHQFH RI GUXJV DOFRKRO
or medication.
EN
7