BOMANN FR 2253 CB Mode D'emploi page 37

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17
CAUTION: Overload!
• If you use extension cords, they should have a conduc-
tor cross-section of at least 1.5 mm
• Do not use any multiple sockets, as this appliance is too
powerful.
Power On / Off
With the temperature control (8) in the position "•", the appli-
ance is switched off.
Set the desired temperature with the temperature control (8).
Use
1. Make sure that the appliance is disconnected from the
mains and is switched off (the pilot lamps (10) / (11) are off).
2. Press the button (7) to open the lid of the appliance.
3. To remove the frying basket (12), reach into the depression
and pull the frying basket handle (13) up, until it latches.
4. Fill the deep-drying fat container with oil or fat (4) (max.
2.5 liters). The filling level must be between the min. and
max. marks.
5. Connect the plug to a properly installed safety plug
socket.
6. Set the desired temperature with the temperature control
(8). Both pilot lamps (10) / (11) light up.
7. Close the lid (3) during the heating phase. The heating
pilot lamp goes out when the set temperature has been
reached.
WARNING:
• Always pull out the plug from the mains socket before cleaning and
wait until the appliance has cooled down.
• Never immerse the housing in water. Doing so may result in an
electric shock or fire.
CAUTION:
• Do not use a wire brush or abrasives for cleaning.
• Do not use abrasive or aggressive cleaners.
Deep-frying fat container and housing
• Pull off the lid (3) in upward direction.
• To change the oil, pour out the oil to the side.
• After use, clean the deep-frying fat container (4), the
deep-frying basket (12), the housing (5) and the lid (3)
with a moist cloth. Possibly, you should use household
detergent.
FR2253CB_IM
8. Fill the deep-frying basket (12). Open the lid (3) and hang
9. Close the lid (3). Loosen the handle (13) by sliding the
.
2
The heating pilot lamp (10) is switched on and off several
times during the deep-frying. This is normal and indicates
that the temperature is being thermostatically controlled
and maintained.
10. After the deep-frying time has passed, open the lid (3)
Hot steam may escape.
11. Now remove the deep-frying basket (12).
12. You can let the oil drip off the deep-fried products for
Ending Operation
1. Turn the temperature control (8) counterclockwise to the
2. Disconnect the mains plug from the socket.
3. Let the frying cool down for a considerable time. Check
Cleaning
Odor and fat vapor filter
• Wipe the filter in the lid with a moistened cloth and a little
household detergent.
• Clean the appliance as described above and let it dry
completely before using it again.
• During longer periods of non-use we recommend storing
the appliance in its original packaging.
• Always keep the appliance at a well-ventilated and dry
location, out of the reach of children.
the basket (12) with the deep-fried products in the recess.
button (14) on the handle. The deep-frying basket (12) is
now in the hot fat.
NOTE:
carefully.
WARNING:
some time. For this, hang the deep-frying basket (12)
with the holder (15) on the edge of the deep-frying fat
container (4).
"•" position.
that the temperature is safe before handling the filled
deep-frying fat container (4) any further.
Storage
37
10.05.16

Publicité

Table des Matières
loading

Table des Matières