Assembly; Operation - Ryobi PMF01 Manuel D'utilisation

WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Keep water and mist discharge pointed away from all
electrical devices to reduce the risk of electrocution or
electric shock.
WARNING:
Ensure all hose connections are secure before using
misting fan. Spilled water and leaks can result in a
slippery surface and create a slip and fall hazard.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
WARNING:
Always remove battery pack from the product when you
are assembling parts, making adjustments, cleaning,
or when not in use. Removing battery pack will prevent
accidental starting that could cause serious personal
injury.
WARNING:
Do not use this product to spray pesticides, liquid
fertilizers, chemicals, or any liquids other than clean
water. Spraying these substances could result in serious
injury or illness to the operator or bystanders.

ASSEMBLY

WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended for use
with this product. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possible serious personal injury.

OPERATION

APPLICATIONS
You may use this product for the following purposes:
 Outdoor cooling while connected to a 5-gallon bucket or
a garden hose
 Fan only
FAN LOW/OFF/HIGH SWITCH
See Figure 1, page 9.
The LOW/OFF/HIGH fan switch is located on the left front
of the base.
 To select LOW speed, press ( I ).
 To select HIGH speed, press ( II ).
 To turn the fan OFF, select the center position ( O ).
PUMP LOW/OFF/HIGH SWITCH
See Figure 1, page 9.
The LOW/OFF/HIGH pump switch is located on the right
front of the base.
 To select LOW speed, press ( I ).
 To select HIGH speed, press ( II ).
 To turn the pump OFF, select the center position ( O ).
INSTALLING/REMOVING THE BATTERY
PACK
See Figure 2, page 9.
NOTE: This product is not recommended for use with RYOBI
ONE+ battery packs larger than 4.0Ah. If installed, large
capacity battery packs will prevent the battery cover from
closing completely exposing the battery and the battery port
to moisture, debris, and other contaminants.
 Set both switches to the OFF ( O ) position.
 Press the tab to open the battery compartment latch.
 Insert the battery pack into the battery port.
 Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured before
beginning operation.
 Close the battery compartment cover and press until it
snaps shut.
5 — English