Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
GC
™
200 IP Marine Camera
Installation Instructions
Getting Started
See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
Mounting Considerations
You can mount the camera upside-down or sideways. You can
reverse the camera image to use in rearview mode. See your
chartplotter owner's manual for instructions.
• You must mount the camera in a location where it is not
submerged.
• You should test the camera in your desired location before
you permanently mount the camera.
• You should mount the camera in a location strong enough to
support the weight of the device.
• You should mount the camera so the LED is visible.
• You should mount the camera so the cables can be
connected easily.
• You should mount the camera in a location where it cannot
be damaged by docks, pilings, or other pieces of equipment.
• You should mount the camera so it does not present a
hazard in doorways or walkways.
• You should mount the camera in a location where you can
remove the camera.
• You should mount the camera in a location that is at or
outside of the compass-safe distance listed in the product
specifications.
Tools Needed
1
• Drill and 2 mm (
/
in.) drill bit
16
• Pozidriv
screwdriver
®
Mounting the Camera
1
Secure the template to the mounting location.
1
2
Using a 2 mm (
/
in.) drill bit, drill the pilot holes.
16
3
Using the included hex wrench, loosen the screw in the side
of the camera base.
4
Remove the base from the camera body.
5
Feed the camera cables through the camera base, or through
one of the cable channels.
6
Align the camera base with the pilot holes, and secure the
camera base
with the washers
2
WARNING
and screws
.
7
Attach the camera
to the base, and tighten the screw in the
camera base.
8
Connect the camera cables.
9
Align the slots on the camera base
and turn the collar
until it locks.
Installation Considerations
You must update your chartplotter software to view the camera
feed on your chartplotter. See your chartplotter manual for
software update instructions.
Installation Diagram with Direct Power
GC
200 IP marine camera
™
Garmin
Marine Network cable small connector
®
Garmin Marine Network Adapter Cable small to large
(010-12531-01)
12 Vdc power source (not included)
7.5 A fast-acting fuse (required, not included)
You must connect the power wire through a 7.5 A fast-acting fuse
(not included). Without a fuse, the device can malfunction.
Garmin chartplotter (not included)
Installation Diagram with a Garmin Power Module
GC 200 IP marine camera
Garmin Marine Network cable small connector
Power module (010-12527-00 - not included)
In-line switch (not included)
12 or 24 Vdc power source (not included)
Chartplotter (not included)
with the collar lugs
NOTICE
Installation Instructions
,
Publicité
Table des Matières
