Using The Printer - Samsung BIXOLON SRP-350 Guide De L'utilisateur

1-8. Using the Printer

Control Panel
Button
The button can be disabled by the ESC c 5 command.
Press the FEED button once to advance paper one line. You can also hold down the
FEED button to feed paper continuously.
Panel lights
POWER
The POWER light is on whenever the printer is on.
ERROR
This indicates an error.
PAPER OUT
This light indicates the near end of the paper roll. Install a new paper roll and the
printer Will continue printing.
When the light blinks, it indicates the self-test printing standby state or macro
execution Standby state when the macro execution command is used.
12
Serial Interface(RS-232C, RS-485) Specification
DIP Switch Set 1 Functions
SW FUNCTION ON
1 Auto Line Feed Always
enabled
2 Reserved -
3 Handshaking XON/OFF
4 Word length 7 bits
5 Parity check Yes
6 Parity selection EVEN
7 Baud rate selection Refer to the Following Table
8
Baud rate selection
Transmission speed
9600 baud
19200 baud
38400 baud
57600 baud
Dip Switch Set 2 Functions
SW FUNCTION ON
1 Emulation STAR
2 Reserved -
3 Reserved -
Busy
4 •Receive Buffer Full
Condition
5 Select
Refer to the Following Table
Print Density
6
Near End
7 Disable
Sensor Status
8 Reserved -
Print Density
Print Density
1 ( Light )
2
3
4 ( Dark )
13
OFF DEFAULT
Always OFF
disabled
- OFF
DTR/DSR OFF
8 bits OFF
No OFF
ODD OFF
ON
OFF
SW – 7 SW – 8
ON OFF
OFF OFF
ON ON
OFF ON
OFF DEFAULT
EPSON OFF
- OFF
- OFF
•Offline
OFF
•Receive Buffer Full
OFF
OFF
Enable OFF
- OFF
SW - 5 SW – 6
ON ON
OFF OFF
ON OFF
OFF ON