Conrad N150 Mode D'emploi page 55

• You can change the IP address of the access point in the fi rst confi guration window. It would be
sensible, e.g. when you assign it an IP address in the range of your router to later access the
access point again easily without effort. If your router has, e.g. the address 192.168.178.1, you
assign the AP, e.g. the IP 192.168.178.250 . You only need to observe that the fi rst three blocks
remain the same and the last block is not yet present in your network. Best leave the "Subnet
Mask" unchanged.
• Now click "Next".
• The WLAN is confi gured on this page. If desired, change the WLAN name fi rst. For this, enter
any name of letters and fi gures behind "Network Name (SSID)". Underscore and dashes are
also permitted.
Open the menu behind "Security Mode" and best select "WPA2-PSK" to activate encryption.
Enter the safest password possible in the fi eld "Pre-Shared Key". The same characters as in
the name are permitted here. The password must consist of at least 8 characters.
Click the button "Apply" to save and complete setup.
55